Enter/edit GPS coordinates for a jobsite
Overview
The user can enter manually Longitude and Latitude of the jobsite in the Edit Jobsite Information panel. Until now these coordinates were automatically loaded when the address was chosen and could not be changed.
Key Benefits
If the jobsite doesn’t have an address and the system cannot generate automatically the Latitude and Longitude the user can enter manually the coordinates
The user can change the coordinates if the loaded ones are not correct
Specifics
Select or create a job and double click on it to open the Add/Edit Job Information panel
Navigate to Jobsite (Click for list) section OR click on Jobsite Information tab
Job Information tab Click on DRILL button and then PENCIL button to open Edit Jobsite Information panel
The user can enter manually the Latitude and Longitude OR can enter the address and these coordinates will be loaded automatically. Then the coordinates can be edited again.
Configuration
The functionality comes with the newest version (2.2210) of the Rapid ERP application. No need for additional configuration.
Comments
0 comments
Article is closed for comments.